屏通触摸屏与日本FX3U-ENET模块通讯线制作与通讯参数设置 - 工控编程吧

上传

点击文件名下载附件

Mitsubishi -FX3U-ENET/ENET-L
此技术文件用于说明当使用触控屏时，如何与 FX3U-ENET/ENET-L正确进行连线以及相关设置
需要注意的事项。
(适用于FX3U-ENET/ENET-L通信协议系列，本文件以 FX3U-ENET -L实测)

Mitsubishi -FX3U-ENET/ENET-L setting
1. FX3U-ENET 控制器设置:
注:须安装FX special function utility 软体
      ENET/ENET-L设定软体不同，请注意

2、FX3U-ENET 参数设定
(1)开启软体=>选择Module 0
(2)设定Operational settings
   Communication data code       : Binary code
   Initialtiming                   :Always wait for OPNE
(Communication possible at STOP time)
   IP address                   :XXX.XXX.XXX.XXX(ex:172.21.250.88)
   Send frame setting             :Ethernet(v2.0)
   TCP Existence confirmation setting  :Use the keepAlive

   (3) Open settings
   Protocol  :TCP
   Open system                      :Unpassive
   Fixed buffer                      :send
   Fixed buffer communication procedure

rocedure exist(MC)
Pairing open

isable
   Existence confirmation             :NO confim
   Host station Port NO.(DEC)          :range of 1025~65534(ex:5001~5004)
                                       Procedure exist(MC)只可设定四组
                                       Ex:5001~5004

   (4) 将参数写入PLC即可

HMI Setting
1.  选择Device/Server Setting: Mitsubishi Electric Corp.. --- Melsec-FX3U
(MC-Protocol) 设定

通讯设定: IP address and Host station Port NO 请参照PLC

PLC Device List
Word Devices:

Bit Devices:

接线图
Ethernet Cable Diagram
(, 下载次数: 0)